Custom Boning — Velvet with Heat-Cut Edge
We supply boning to garment factories and brands, built in Velvet with heat-cut edge for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is flex direction, matched to where the panel needs to hold, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Boning |
|---|---|
| Width | 5 mm |
| Type | casing-covered boning |
| Base material | Velvet |
| Finish / process | Heat-Cut Edge |
| Colour options | 24 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 3000 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 25-50 days after approval |
| Compliance | SNI or SIRIM documentation per destination; OEKO-TEX Standard 100 for dyes and trims |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Soft Enamel Fill — available on Velvet, quoted per position and per colour.
- Crochet — available on Velvet, quoted per position and per colour.
- Ultrasonic Welding — available on Velvet, quoted per position and per colour.
- Rubber Coating — available on Velvet, quoted per position and per colour.
- Pleating — available on Velvet, quoted per position and per colour.
- Embroidery — available on Velvet, quoted per position and per colour.
- Overlocked Edge — available on Velvet, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed width
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with heat-cut edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for OEKO-TEX Standard 100 for dyes and trims are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same flex direction.
FAQ
Which compliance documents do you provide?
We prepare OEKO-TEX Standard 100 for dyes and trims and the supporting test reports for the destination market.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
How long does sampling take?
A first sample takes 10 working days, and each revision about 3 days.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Start your boning programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
