Custom Hang Tag — Horn with Hot Foil Stamping
We supply hang tag to garment factories and brands, built in Horn with hot foil stamping for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is string and fastener strength, because a torn tag means no barcode, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Hang Tag |
|---|---|
| Size | 50 x 90 mm |
| Finishing | hot foil |
| Base material | Horn |
| Finish / process | Hot Foil Stamping |
| Colour options | 16 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 2000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; colour fastness to washing, rubbing and light |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Tassel Finish — available on Horn, quoted per position and per colour.
- Anti-Rust Treatment — available on Horn, quoted per position and per colour.
- Sewn Edge — available on Horn, quoted per position and per colour.
- Digital Printing — available on Horn, quoted per position and per colour.
- Laser Engraving — available on Horn, quoted per position and per colour.
- Embossing — available on Horn, quoted per position and per colour.
- Powder Coating — available on Horn, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with hot foil stamping applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same string and fastener strength.
FAQ
Which compliance documents do you provide?
We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Start your hang tag programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
