Custom Hang Tag in Nylon Fabric with Paint Spray for E-commerce and Small-Batch Brands

Custom Hang Tag — Nylon Fabric with Paint Spray

We supply hang tag to garment factories and brands, built in Nylon Fabric with paint spray for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is string and fastener strength, because a torn tag means no barcode, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.

The failures here are predictable: colour drift between the approved sample and the bulk trim, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Embossing — available on Nylon Fabric, quoted per position and per colour.
• Dye-Sublimation Printing — available on Nylon Fabric, quoted per position and per colour.
• UV Printing — available on Nylon Fabric, quoted per position and per colour.
• Epoxy Dome — available on Nylon Fabric, quoted per position and per colour.
• Rhinestone Setting — available on Nylon Fabric, quoted per position and per colour.
• Ultrasonic Welding — available on Nylon Fabric, quoted per position and per colour.
• Beaded Detail — available on Nylon Fabric, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with paint spray applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same string and fastener strength.

FAQ

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How long does sampling take?

A first sample takes 10 working days, and each revision about 4 days.

Which compliance documents do you provide?

We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Start your hang tag programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.