Custom Hang Tag in Coconut Shell with Injection Moulding for Childrenswear and Schoolwear

Custom Hang Tag — Coconut Shell with Injection Moulding

We supply hang tag to garment factories and brands, built in Coconut Shell with injection moulding for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is print registration on the barcode area, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Sequin Stitching — available on Coconut Shell, quoted per position and per colour.
• Anti-Rust Treatment — available on Coconut Shell, quoted per position and per colour.
• Laser Engraving — available on Coconut Shell, quoted per position and per colour.
• Beaded Detail — available on Coconut Shell, quoted per position and per colour.
• Hot Foil Stamping — available on Coconut Shell, quoted per position and per colour.
• Rubber Coating — available on Coconut Shell, quoted per position and per colour.
• Dye-Sublimation Printing — available on Coconut Shell, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with injection moulding applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same print registration on the barcode area.

FAQ

How long does sampling take?

A first sample takes 10 working days, and each revision about 5 days.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Start your hang tag programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.