Custom Button in Neoprene with Powder Coating for Bridal and Eveningwear Studios

Custom Button — Neoprene with Powder Coating

We supply button to garment factories and brands, built in Neoprene with powder coating for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is hole burr, because a rough burr cuts thread on the line, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.

The failures here are predictable: a supplier who disappears once the deposit is paid, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Digital Printing — available on Neoprene, quoted per position and per colour.
• Overlocked Edge — available on Neoprene, quoted per position and per colour.
• Nickel Plating — available on Neoprene, quoted per position and per colour.
• Fringe Finish — available on Neoprene, quoted per position and per colour.
• Injection Moulding — available on Neoprene, quoted per position and per colour.
• Heat Transfer Printing — available on Neoprene, quoted per position and per colour.
• Anti-Rust Treatment — available on Neoprene, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed ligne
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with powder coating applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole burr.

FAQ

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

How long does sampling take?

A first sample takes 14 working days, and each revision about 5 days.

What is the minimum order?

Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Start your button programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.