Custom Shoulder Pad — Mesh with Piece Dyeing
We supply shoulder pad to garment factories and brands, built in Mesh with piece dyeing for uniform and corporate programmes. On a trim like this the specification that decides the outcome is recovery after compression, because a pad that flattens is visible, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Shoulder Pad |
|---|---|
| Thickness | 20 mm |
| Type | covered pad |
| Base material | Mesh |
| Finish / process | Piece Dyeing |
| Colour options | 24 Pantone-matched shades |
| Packing | carded |
| MOQ | 2000 pieces per style per finish |
| Sampling | 14 working days, 4 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | GB 18401 safety classification with GB/T 29862 fibre labelling; EN 71 part 3 for decorative components |
| Ship to | Shanghai or Shenzhen (Mainland China) |
What buyers can customise
- Die-Casting — available on Mesh, quoted per position and per colour.
- Piece Dyeing — available on Mesh, quoted per position and per colour.
- Hard Enamel Fill — available on Mesh, quoted per position and per colour.
- Paint Spray — available on Mesh, quoted per position and per colour.
- Woven Jacquard — available on Mesh, quoted per position and per colour.
- Embroidery — available on Mesh, quoted per position and per colour.
- Rubber Coating — available on Mesh, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed thickness
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with piece dyeing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same recovery after compression.
FAQ
How long does sampling take?
A first sample takes 14 working days, and each revision about 4 days.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your shoulder pad programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
