Custom Shoulder Pad — Polyester with Injection Moulding
We supply shoulder pad to garment factories and brands, built in Polyester with injection moulding for denim and workwear programmes. On a trim like this the specification that decides the outcome is wash stability of the foam, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Shoulder Pad |
|---|---|
| Thickness | 20 mm |
| Type | covered pad |
| Base material | Polyester |
| Finish / process | Injection Moulding |
| Colour options | 8 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 2000 pieces per style per finish |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | SNI or SIRIM documentation per destination; azo dye-free declaration |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Overlocked Edge — available on Polyester, quoted per position and per colour.
- Epoxy Dome — available on Polyester, quoted per position and per colour.
- Pleating — available on Polyester, quoted per position and per colour.
- Sewn Edge — available on Polyester, quoted per position and per colour.
- Braided Weave — available on Polyester, quoted per position and per colour.
- Injection Moulding — available on Polyester, quoted per position and per colour.
- Piece Dyeing — available on Polyester, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed thickness
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for azo dye-free declaration are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same wash stability of the foam.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Which compliance documents do you provide?
We prepare azo dye-free declaration and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Start your shoulder pad programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
