Custom Shoulder Pad — Spandex Blend with Heat-Cut Edge
We supply shoulder pad to garment factories and brands, built in Spandex Blend with heat-cut edge for uniform and corporate programmes. On a trim like this the specification that decides the outcome is recovery after compression, because a pad that flattens is visible, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Shoulder Pad |
|---|---|
| Thickness | 15 mm |
| Type | covered pad |
| Base material | Spandex Blend |
| Finish / process | Heat-Cut Edge |
| Colour options | 24 Pantone-matched shades |
| Packing | reel packed |
| MOQ | 3000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | SNI or SIRIM documentation per destination; GRS recycled content claim |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Knitted Structure — available on Spandex Blend, quoted per position and per colour.
- Rubber Coating — available on Spandex Blend, quoted per position and per colour.
- Injection Moulding — available on Spandex Blend, quoted per position and per colour.
- Powder Coating — available on Spandex Blend, quoted per position and per colour.
- Woven Jacquard — available on Spandex Blend, quoted per position and per colour.
- Epoxy Dome — available on Spandex Blend, quoted per position and per colour.
- Braided Weave — available on Spandex Blend, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed thickness
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with heat-cut edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same recovery after compression.
FAQ
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
What is the minimum order?
Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.
Which compliance documents do you provide?
We prepare GRS recycled content claim and the supporting test reports for the destination market.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your shoulder pad programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
