Custom Cord Stopper — ABS Plastic with Epoxy Dome
We supply cord stopper to garment factories and brands, built in ABS Plastic with epoxy dome for denim and workwear programmes. On a trim like this the specification that decides the outcome is grip force on the actual cord, tested both dry and wet, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: shade variation within one carton, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Cord Stopper |
|---|---|
| Bore | 5 mm |
| Type | spring-loaded stopper |
| Base material | ABS Plastic |
| Finish / process | Epoxy Dome |
| Colour options | 24 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 5000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | SNI or SIRIM documentation per destination; CPSIA lead and phthalate testing |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Heat Transfer Printing — available on ABS Plastic, quoted per position and per colour.
- Brushed Finish — available on ABS Plastic, quoted per position and per colour.
- Debossing — available on ABS Plastic, quoted per position and per colour.
- Anti-Rust Treatment — available on ABS Plastic, quoted per position and per colour.
- Die-Casting — available on ABS Plastic, quoted per position and per colour.
- Hot Foil Stamping — available on ABS Plastic, quoted per position and per colour.
- Hard Enamel Fill — available on ABS Plastic, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed bore
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with epoxy dome applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same grip force on the actual cord.
FAQ
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your cord stopper programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
