Custom Cord Stopper — Copper with Injection Moulding
We supply cord stopper to garment factories and brands, built in Copper with injection moulding for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is spring life across repeated release cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: a supplier who disappears once the deposit is paid, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Cord Stopper |
|---|---|
| Bore | 8 mm |
| Type | cord end |
| Base material | Copper |
| Finish / process | Injection Moulding |
| Colour options | 12 Pantone-matched shades |
| Packing | carded |
| MOQ | 500 pieces per style per finish |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | SNI or SIRIM documentation per destination; GRS recycled content claim |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Paint Spray — available on Copper, quoted per position and per colour.
- Heat Transfer Printing — available on Copper, quoted per position and per colour.
- Screen Printing — available on Copper, quoted per position and per colour.
- Anti-Rust Treatment — available on Copper, quoted per position and per colour.
- Gunmetal Plating — available on Copper, quoted per position and per colour.
- Debossing — available on Copper, quoted per position and per colour.
- Embossing — available on Copper, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed bore
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring life across repeated release cycles.
FAQ
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 14 working days, and each revision about 5 days.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Which compliance documents do you provide?
We prepare GRS recycled content claim and the supporting test reports for the destination market.
Start your cord stopper programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
