Custom Cord Stopper — TPU with Rubber Coating
We supply cord stopper to garment factories and brands, built in TPU with rubber coating for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is grip force on the actual cord, tested both dry and wet, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Cord Stopper |
|---|---|
| Bore | 5 mm |
| Type | single-hole toggle |
| Base material | TPU |
| Finish / process | Rubber Coating |
| Colour options | 12 Pantone-matched shades |
| Packing | reel packed |
| MOQ | 1000 pieces per style per finish |
| Sampling | 7 working days, 4 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | SNI or SIRIM documentation per destination; REACH nickel-release test for metal findings |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Sewn Edge — available on TPU, quoted per position and per colour.
- Paint Spray — available on TPU, quoted per position and per colour.
- Gunmetal Plating — available on TPU, quoted per position and per colour.
- Hard Enamel Fill — available on TPU, quoted per position and per colour.
- Gold Plating — available on TPU, quoted per position and per colour.
- Chrome Plating — available on TPU, quoted per position and per colour.
- Heat Transfer Printing — available on TPU, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed bore
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with rubber coating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same grip force on the actual cord.
FAQ
How long does sampling take?
A first sample takes 7 working days, and each revision about 4 days.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Start your cord stopper programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
