Custom Cord Stopper — Natural Rubber with Sewn Edge
We supply cord stopper to garment factories and brands, built in Natural Rubber with sewn edge for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is spring life across repeated release cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Cord Stopper |
|---|---|
| Bore | 5 mm |
| Type | spring-loaded stopper |
| Base material | Natural Rubber |
| Finish / process | Sewn Edge |
| Colour options | 12 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 3000 pieces per style per finish |
| Sampling | 10 working days, 5 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; REACH nickel-release test for metal findings |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Soft Enamel Fill — available on Natural Rubber, quoted per position and per colour.
- Hot Foil Stamping — available on Natural Rubber, quoted per position and per colour.
- Gunmetal Plating — available on Natural Rubber, quoted per position and per colour.
- Chrome Plating — available on Natural Rubber, quoted per position and per colour.
- Embossing — available on Natural Rubber, quoted per position and per colour.
- Die-Casting — available on Natural Rubber, quoted per position and per colour.
- Powder Coating — available on Natural Rubber, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed bore
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with sewn edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring life across repeated release cycles.
FAQ
How long does sampling take?
A first sample takes 10 working days, and each revision about 5 days.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Which compliance documents do you provide?
We prepare REACH nickel-release test for metal findings and the supporting test reports for the destination market.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your cord stopper programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
