Custom Rib Cuff — Polyester with Injection Moulding
We supply rib cuff to garment factories and brands, built in Polyester with injection moulding for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is recovery after stretch, because a cuff that bags stays bagged, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: shade variation within one carton, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Rib Cuff |
|---|---|
| Width | 6 cm |
| Construction | 1x1 rib |
| Base material | Polyester |
| Finish / process | Injection Moulding |
| Colour options | 12 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 2000 pieces per style per finish |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; azo dye-free declaration |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Pantone Colour Matching — available on Polyester, quoted per position and per colour.
- Injection Moulding — available on Polyester, quoted per position and per colour.
- Overlocked Edge — available on Polyester, quoted per position and per colour.
- Pleating — available on Polyester, quoted per position and per colour.
- Beaded Detail — available on Polyester, quoted per position and per colour.
- Heat-Cut Edge — available on Polyester, quoted per position and per colour.
- Sewn Edge — available on Polyester, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed width
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for azo dye-free declaration are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same recovery after stretch.
FAQ
How long does sampling take?
A first sample takes 14 working days, and each revision about 5 days.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your rib cuff programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
