Custom Lace Trim — Satin with Pleating
We supply lace trim to garment factories and brands, built in Satin with pleating for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is stretch and recovery where the lace is used on a fitted panel, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Lace Trim |
|---|---|
| Width | 30 mm |
| Type | chantilly lace |
| Base material | Satin |
| Finish / process | Pleating |
| Colour options | 24 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 5000 pieces per style per finish |
| Sampling | 7 working days, 4 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; EN 71 part 3 for decorative components |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Stamping — available on Satin, quoted per position and per colour.
- Rhinestone Setting — available on Satin, quoted per position and per colour.
- Yarn Dyeing — available on Satin, quoted per position and per colour.
- Woven Jacquard — available on Satin, quoted per position and per colour.
- Heat-Cut Edge — available on Satin, quoted per position and per colour.
- Mercerised Finish — available on Satin, quoted per position and per colour.
- Ultrasonic Welding — available on Satin, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed width
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with pleating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same stretch and recovery where the lace is used on a fitted panel.
FAQ
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 7 working days, and each revision about 4 days.
Start your lace trim programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
