Custom Tag Pin — Stainless Steel with Debossing
We supply tag pin to garment factories and brands, built in Stainless Steel with debossing for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: a finish that tarnishes or rubs off after washing, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 75 mm |
| Type | fine fabric pin |
| Base material | Stainless Steel |
| Finish / process | Debossing |
| Colour options | 16 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 1000 pieces per style per finish |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; EN 71 part 3 for decorative components |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Debossing — available on Stainless Steel, quoted per position and per colour.
- Epoxy Dome — available on Stainless Steel, quoted per position and per colour.
- Hot Foil Stamping — available on Stainless Steel, quoted per position and per colour.
- Powder Coating — available on Stainless Steel, quoted per position and per colour.
- Stamping — available on Stainless Steel, quoted per position and per colour.
- Sewn Edge — available on Stainless Steel, quoted per position and per colour.
- Heat Transfer Printing — available on Stainless Steel, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with debossing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
Start your tag pin programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
