Custom Tag Pin — Brass with Rubber Coating
We supply tag pin to garment factories and brands, built in Brass with rubber coating for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 15 mm |
| Type | barbless pin |
| Base material | Brass |
| Finish / process | Rubber Coating |
| Colour options | 24 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 500 pieces per style per finish |
| Sampling | 7 working days, 5 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | GB 18401 safety classification with GB/T 29862 fibre labelling; colour fastness to washing, rubbing and light |
| Ship to | Shanghai or Shenzhen (Mainland China) |
What buyers can customise
- Die-Casting — available on Brass, quoted per position and per colour.
- Laser Engraving — available on Brass, quoted per position and per colour.
- Epoxy Dome — available on Brass, quoted per position and per colour.
- Rubber Coating — available on Brass, quoted per position and per colour.
- Injection Moulding — available on Brass, quoted per position and per colour.
- Screen Printing — available on Brass, quoted per position and per colour.
- Digital Printing — available on Brass, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with rubber coating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.
FAQ
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
How long does sampling take?
A first sample takes 7 working days, and each revision about 5 days.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Start your tag pin programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
