Custom Tag Pin — Stainless Steel with Ultrasonic Welding
We supply tag pin to garment factories and brands, built in Stainless Steel with ultrasonic welding for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is needle compatibility with the tagging gun on your line, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 50 mm |
| Type | loop lock pin |
| Base material | Stainless Steel |
| Finish / process | Ultrasonic Welding |
| Colour options | 12 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; OEKO-TEX Standard 100 for dyes and trims |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Ultrasonic Welding — available on Stainless Steel, quoted per position and per colour.
- Epoxy Dome — available on Stainless Steel, quoted per position and per colour.
- UV Printing — available on Stainless Steel, quoted per position and per colour.
- Heat Transfer Printing — available on Stainless Steel, quoted per position and per colour.
- Embossing — available on Stainless Steel, quoted per position and per colour.
- Debossing — available on Stainless Steel, quoted per position and per colour.
- Hard Enamel Fill — available on Stainless Steel, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with ultrasonic welding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for OEKO-TEX Standard 100 for dyes and trims are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same needle compatibility with the tagging gun on your line.
FAQ
How long does sampling take?
A first sample takes 12 working days, and each revision about 3 days.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Which compliance documents do you provide?
We prepare OEKO-TEX Standard 100 for dyes and trims and the supporting test reports for the destination market.
Start your tag pin programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
