Custom Tag Pin in ABS Plastic with Dye-Sublimation Printing for E-commerce and Small-Batch Brands

Custom Tag Pin — ABS Plastic with Dye-Sublimation Printing

We supply tag pin to garment factories and brands, built in ABS Plastic with dye-sublimation printing for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is needle compatibility with the tagging gun on your line, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: colour drift between the approved sample and the bulk trim, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Injection Moulding — available on ABS Plastic, quoted per position and per colour.
• Anti-Rust Treatment — available on ABS Plastic, quoted per position and per colour.
• Laser Engraving — available on ABS Plastic, quoted per position and per colour.
• Hard Enamel Fill — available on ABS Plastic, quoted per position and per colour.
• Screen Printing — available on ABS Plastic, quoted per position and per colour.
• Heat Transfer Printing — available on ABS Plastic, quoted per position and per colour.
• Hot Foil Stamping — available on ABS Plastic, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with dye-sublimation printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same needle compatibility with the tagging gun on your line.

FAQ

How long does sampling take?

A first sample takes 10 working days, and each revision about 3 days.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

What is the minimum order?

Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.

Start your tag pin programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.