Custom Tag Pin — Polyethylene (PE) with Stamping
We supply tag pin to garment factories and brands, built in Polyethylene (PE) with stamping for uniform and corporate programmes. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: shade variation within one carton, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare UKCA and REACH documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 25 mm |
| Type | standard tag pin |
| Base material | Polyethylene (PE) |
| Finish / process | Stamping |
| Colour options | 6 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 500 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | UKCA and REACH documentation; CPSIA lead and phthalate testing |
| Ship to | Felixstowe (the United Kingdom) |
What buyers can customise
- Laser Engraving — available on Polyethylene (PE), quoted per position and per colour.
- Overlocked Edge — available on Polyethylene (PE), quoted per position and per colour.
- Hot Foil Stamping — available on Polyethylene (PE), quoted per position and per colour.
- Rubber Coating — available on Polyethylene (PE), quoted per position and per colour.
- Digital Printing — available on Polyethylene (PE), quoted per position and per colour.
- Injection Moulding — available on Polyethylene (PE), quoted per position and per colour.
- Dye-Sublimation Printing — available on Polyethylene (PE), quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with stamping applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.
FAQ
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
Start your tag pin programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
