Custom Tag Pin in ABS Plastic with Heat Transfer Printing for Childrenswear and Schoolwear

Custom Tag Pin — ABS Plastic with Heat Transfer Printing

We supply tag pin to garment factories and brands, built in ABS Plastic with heat transfer printing for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.

The failures here are predictable: packing that arrives mixed and unusable on the line, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Heat Transfer Printing — available on ABS Plastic, quoted per position and per colour.
• Powder Coating — available on ABS Plastic, quoted per position and per colour.
• Debossing — available on ABS Plastic, quoted per position and per colour.
• Anti-Rust Treatment — available on ABS Plastic, quoted per position and per colour.
• Rubber Coating — available on ABS Plastic, quoted per position and per colour.
• Overlocked Edge — available on ABS Plastic, quoted per position and per colour.
• Stamping — available on ABS Plastic, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with heat transfer printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.

FAQ

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

What is the minimum order?

Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.

Start your tag pin programme

Tell us the quantity, the target price and the delivery window — we will tell you what is realistic before you commit.