Custom Tag Pin in Polycarbonate with Heat Transfer Printing for Bridal and Eveningwear Studios

Custom Tag Pin — Polycarbonate with Heat Transfer Printing

We supply tag pin to garment factories and brands, built in Polycarbonate with heat transfer printing for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is material that does not damage fine fabric, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: packing that arrives mixed and unusable on the line, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Epoxy Dome — available on Polycarbonate, quoted per position and per colour.
• Injection Moulding — available on Polycarbonate, quoted per position and per colour.
• Heat Transfer Printing — available on Polycarbonate, quoted per position and per colour.
• Rubber Coating — available on Polycarbonate, quoted per position and per colour.
• Offset Printing — available on Polycarbonate, quoted per position and per colour.
• Soft Enamel Fill — available on Polycarbonate, quoted per position and per colour.
• Overlocked Edge — available on Polycarbonate, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with heat transfer printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same material that does not damage fine fabric.

FAQ

What is the minimum order?

Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

Start your tag pin programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.