Custom Mannequin — Cork with Heat-Cut Edge
We supply mannequin to garment factories and brands, built in Cork with heat-cut edge for denim and workwear programmes. On a trim like this the specification that decides the outcome is surface finish, because fabric snags on a rough form, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: packing that arrives mixed and unusable on the line, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Mannequin |
|---|---|
| Height | 150 cm |
| Type | full body form |
| Base material | Cork |
| Finish / process | Heat-Cut Edge |
| Colour options | 12 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 500 pieces per style per finish |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; colour fastness to washing, rubbing and light |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Dye-Sublimation Printing — available on Cork, quoted per position and per colour.
- Epoxy Dome — available on Cork, quoted per position and per colour.
- Crochet — available on Cork, quoted per position and per colour.
- Screen Printing — available on Cork, quoted per position and per colour.
- Laser Engraving — available on Cork, quoted per position and per colour.
- Heat-Cut Edge — available on Cork, quoted per position and per colour.
- Hot Foil Stamping — available on Cork, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed height
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with heat-cut edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same surface finish.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Which compliance documents do you provide?
We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 14 working days, and each revision about 3 days.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your mannequin programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
