Custom Thread Trimmer — TPU with Brushed Finish
We supply thread trimmer to garment factories and brands, built in TPU with brushed finish for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is tip safety, since trimming happens close to the finished garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Thread Trimmer |
|---|---|
| Blade length | 35 mm |
| Type | serrated blade trimmer |
| Base material | TPU |
| Finish / process | Brushed Finish |
| Colour options | 12 Pantone-matched shades |
| Packing | carded |
| MOQ | 3000 pieces per style per finish |
| Sampling | 12 working days, 3 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; EN 71 part 3 for decorative components |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Anti-Rust Treatment — available on TPU, quoted per position and per colour.
- Injection Moulding — available on TPU, quoted per position and per colour.
- Nickel Plating — available on TPU, quoted per position and per colour.
- Ultrasonic Welding — available on TPU, quoted per position and per colour.
- Soft Enamel Fill — available on TPU, quoted per position and per colour.
- Die-Casting — available on TPU, quoted per position and per colour.
- Rubber Coating — available on TPU, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed blade length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with brushed finish applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tip safety.
FAQ
How long does sampling take?
A first sample takes 12 working days, and each revision about 3 days.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
Start your thread trimmer programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
