Custom Thread Trimmer — Iron with Die-Casting
We supply thread trimmer to garment factories and brands, built in Iron with die-casting for denim and workwear programmes. On a trim like this the specification that decides the outcome is blade edge retention across a full shift of trimming, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Thread Trimmer |
|---|---|
| Blade length | 25 mm |
| Type | serrated blade trimmer |
| Base material | Iron |
| Finish / process | Die-Casting |
| Colour options | 8 Pantone-matched shades |
| Packing | reel packed |
| MOQ | 2000 pieces per style per finish |
| Sampling | 12 working days, 4 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; salt spray test for metal finishes |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Rubber Coating — available on Iron, quoted per position and per colour.
- Antique Silver — available on Iron, quoted per position and per colour.
- Gunmetal Plating — available on Iron, quoted per position and per colour.
- Nickel Plating — available on Iron, quoted per position and per colour.
- Stamping — available on Iron, quoted per position and per colour.
- Rose Gold Plating — available on Iron, quoted per position and per colour.
- Overlocked Edge — available on Iron, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed blade length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with die-casting applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same blade edge retention across a full shift of trimming.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Start your thread trimmer programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
