Custom Mannequin in PU Leather with Hard Enamel Fill for Uniform and Corporate Programmes

Custom Mannequin — PU Leather with Hard Enamel Fill

We supply mannequin to garment factories and brands, built in PU Leather with hard enamel fill for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is base stability when a full outfit is pinned on, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.

The failures here are predictable: shade variation within one carton, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Offset Printing — available on PU Leather, quoted per position and per colour.
• Epoxy Dome — available on PU Leather, quoted per position and per colour.
• Heat Transfer Printing — available on PU Leather, quoted per position and per colour.
• Embroidery — available on PU Leather, quoted per position and per colour.
• Soft Enamel Fill — available on PU Leather, quoted per position and per colour.
• Digital Printing — available on PU Leather, quoted per position and per colour.
• Die-Casting — available on PU Leather, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed height
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with hard enamel fill applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same base stability when a full outfit is pinned on.

FAQ

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Which compliance documents do you provide?

We prepare salt spray test for metal finishes and the supporting test reports for the destination market.

How long does sampling take?

A first sample takes 10 working days, and each revision about 5 days.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Start your mannequin programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.