Custom Thread Trimmer — TPU with Sewn Edge
We supply thread trimmer to garment factories and brands, built in TPU with sewn edge for uniform and corporate programmes. On a trim like this the specification that decides the outcome is tip safety, since trimming happens close to the finished garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Thread Trimmer |
|---|---|
| Blade length | 25 mm |
| Type | thread clipper |
| Base material | TPU |
| Finish / process | Sewn Edge |
| Colour options | 6 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 500 pieces per style per finish |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; salt spray test for metal finishes |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Injection Moulding — available on TPU, quoted per position and per colour.
- Rose Gold Plating — available on TPU, quoted per position and per colour.
- Stamping — available on TPU, quoted per position and per colour.
- Rubber Coating — available on TPU, quoted per position and per colour.
- Gold Plating — available on TPU, quoted per position and per colour.
- UV Printing — available on TPU, quoted per position and per colour.
- Brushed Finish — available on TPU, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed blade length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with sewn edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tip safety.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
Start your thread trimmer programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
