Custom Mannequin — Suede with Injection Moulding
We supply mannequin to garment factories and brands, built in Suede with injection moulding for uniform and corporate programmes. On a trim like this the specification that decides the outcome is measurement accuracy against the size chart you sell, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Mannequin |
|---|---|
| Height | 175 cm |
| Type | part body form |
| Base material | Suede |
| Finish / process | Injection Moulding |
| Colour options | 8 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; EN 71 part 3 for decorative components |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Braided Weave — available on Suede, quoted per position and per colour.
- Mercerised Finish — available on Suede, quoted per position and per colour.
- Powder Coating — available on Suede, quoted per position and per colour.
- Anti-Rust Treatment — available on Suede, quoted per position and per colour.
- Heat-Cut Edge — available on Suede, quoted per position and per colour.
- Epoxy Dome — available on Suede, quoted per position and per colour.
- Laser Engraving — available on Suede, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed height
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same measurement accuracy against the size chart you sell.
FAQ
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Start your mannequin programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
