Custom Thread Trimmer — Iron with Soft Enamel Fill
We supply thread trimmer to garment factories and brands, built in Iron with soft enamel fill for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is spring tension, which decides fatigue over a long run, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Thread Trimmer |
|---|---|
| Blade length | 25 mm |
| Type | thread clipper |
| Base material | Iron |
| Finish / process | Soft Enamel Fill |
| Colour options | 8 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 3000 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | REACH and GPSR documentation; EN 71 part 3 for decorative components |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Anti-Rust Treatment — available on Iron, quoted per position and per colour.
- Rose Gold Plating — available on Iron, quoted per position and per colour.
- Paint Spray — available on Iron, quoted per position and per colour.
- Soft Enamel Fill — available on Iron, quoted per position and per colour.
- Gunmetal Plating — available on Iron, quoted per position and per colour.
- Overlocked Edge — available on Iron, quoted per position and per colour.
- Injection Moulding — available on Iron, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed blade length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with soft enamel fill applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring tension.
FAQ
How long does sampling take?
A first sample takes 10 working days, and each revision about 3 days.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
Start your thread trimmer programme
Tell us the quantity, the target price and the delivery window — we will tell you what is realistic before you commit.
