Custom Thread Trimmer — Acrylic with Anti-Rust Treatment
We supply thread trimmer to garment factories and brands, built in Acrylic with anti-rust treatment for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is spring tension, which decides fatigue over a long run, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare UKCA and REACH documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Thread Trimmer |
|---|---|
| Blade length | 35 mm |
| Type | spring-action trimmer |
| Base material | Acrylic |
| Finish / process | Anti-Rust Treatment |
| Colour options | 24 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 500 pieces per style per finish |
| Sampling | 10 working days, 5 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | UKCA and REACH documentation; EN 71 part 3 for decorative components |
| Ship to | Felixstowe (the United Kingdom) |
What buyers can customise
- Soft Enamel Fill — available on Acrylic, quoted per position and per colour.
- Black Oxide — available on Acrylic, quoted per position and per colour.
- Overlocked Edge — available on Acrylic, quoted per position and per colour.
- Rubber Coating — available on Acrylic, quoted per position and per colour.
- Die-Casting — available on Acrylic, quoted per position and per colour.
- Powder Coating — available on Acrylic, quoted per position and per colour.
- Mirror Polish — available on Acrylic, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed blade length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with anti-rust treatment applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring tension.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 10 working days, and each revision about 5 days.
Start your thread trimmer programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
