Custom Thread Trimmer — TPU with Epoxy Dome
We supply thread trimmer to garment factories and brands, built in TPU with epoxy dome for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is tip safety, since trimming happens close to the finished garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Thread Trimmer |
|---|---|
| Blade length | 45 mm |
| Type | spring-action trimmer |
| Base material | TPU |
| Finish / process | Epoxy Dome |
| Colour options | 16 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 2000 pieces per style per finish |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; GRS recycled content claim |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Sewn Edge — available on TPU, quoted per position and per colour.
- Stamping — available on TPU, quoted per position and per colour.
- Nickel Plating — available on TPU, quoted per position and per colour.
- Paint Spray — available on TPU, quoted per position and per colour.
- Antique Brass Plating — available on TPU, quoted per position and per colour.
- Epoxy Dome — available on TPU, quoted per position and per colour.
- Ultrasonic Welding — available on TPU, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed blade length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with epoxy dome applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tip safety.
FAQ
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 7 working days, and each revision about 3 days.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Start your thread trimmer programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
