Custom Hang Tag — Cork with Injection Moulding
We supply hang tag to garment factories and brands, built in Cork with injection moulding for denim and workwear programmes. On a trim like this the specification that decides the outcome is string and fastener strength, because a torn tag means no barcode, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Hang Tag |
|---|---|
| Size | 50 x 90 mm |
| Finishing | hot foil |
| Base material | Cork |
| Finish / process | Injection Moulding |
| Colour options | 24 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 1000 pieces per style per finish |
| Sampling | 10 working days, 5 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | REACH and GPSR documentation; CPSIA lead and phthalate testing |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Hot Foil Stamping — available on Cork, quoted per position and per colour.
- Debossing — available on Cork, quoted per position and per colour.
- Rubber Coating — available on Cork, quoted per position and per colour.
- Injection Moulding — available on Cork, quoted per position and per colour.
- Beaded Detail — available on Cork, quoted per position and per colour.
- Overlocked Edge — available on Cork, quoted per position and per colour.
- Epoxy Dome — available on Cork, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same string and fastener strength.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 10 working days, and each revision about 5 days.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your hang tag programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
