Custom Hang Tag — Spandex Blend with Laser Engraving
We supply hang tag to garment factories and brands, built in Spandex Blend with laser engraving for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is print registration on the barcode area, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: a finish that tarnishes or rubs off after washing, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Hang Tag |
|---|---|
| Size | 70 x 140 mm |
| Finishing | matte lamination |
| Base material | Spandex Blend |
| Finish / process | Laser Engraving |
| Colour options | 12 Pantone-matched shades |
| Packing | reel packed |
| MOQ | 2000 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; colour fastness to washing, rubbing and light |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Hot Foil Stamping — available on Spandex Blend, quoted per position and per colour.
- Digital Printing — available on Spandex Blend, quoted per position and per colour.
- Paint Spray — available on Spandex Blend, quoted per position and per colour.
- Epoxy Dome — available on Spandex Blend, quoted per position and per colour.
- Rubber Coating — available on Spandex Blend, quoted per position and per colour.
- Hard Enamel Fill — available on Spandex Blend, quoted per position and per colour.
- Stamping — available on Spandex Blend, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with laser engraving applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same print registration on the barcode area.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Which compliance documents do you provide?
We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 10 working days, and each revision about 3 days.
Start your hang tag programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
