Custom Button in Polyethylene (PE) with Rose Gold Plating for E-commerce and Small-Batch Brands

Custom Button — Polyethylene (PE) with Rose Gold Plating

We supply button to garment factories and brands, built in Polyethylene (PE) with rose gold plating for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is shade match across a full box, since buttons are bought by the gross, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.

The failures here are predictable: shade variation within one carton, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Digital Printing — available on Polyethylene (PE), quoted per position and per colour.
• Paint Spray — available on Polyethylene (PE), quoted per position and per colour.
• Powder Coating — available on Polyethylene (PE), quoted per position and per colour.
• Offset Printing — available on Polyethylene (PE), quoted per position and per colour.
• Die-Casting — available on Polyethylene (PE), quoted per position and per colour.
• Soft Enamel Fill — available on Polyethylene (PE), quoted per position and per colour.
• Hot Foil Stamping — available on Polyethylene (PE), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed ligne
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with rose gold plating applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same shade match across a full box.

FAQ

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Which compliance documents do you provide?

We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Start your button programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.