Custom Button in Resin Rhinestone with Rubber Coating for Denim and Workwear Programmes

Custom Button — Resin Rhinestone with Rubber Coating

We supply button to garment factories and brands, built in Resin Rhinestone with rubber coating for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is shade match across a full box, since buttons are bought by the gross, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Black Oxide — available on Resin Rhinestone, quoted per position and per colour.
• Pantone Colour Matching — available on Resin Rhinestone, quoted per position and per colour.
• Overlocked Edge — available on Resin Rhinestone, quoted per position and per colour.
• Tassel Finish — available on Resin Rhinestone, quoted per position and per colour.
• Gunmetal Plating — available on Resin Rhinestone, quoted per position and per colour.
• Embossing — available on Resin Rhinestone, quoted per position and per colour.
• Sequin Stitching — available on Resin Rhinestone, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed ligne
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with rubber coating applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same shade match across a full box.

FAQ

Which compliance documents do you provide?

We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Start your button programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.