Custom Button — ABS Plastic with Ultrasonic Welding
We supply button to garment factories and brands, built in ABS Plastic with ultrasonic welding for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is hole burr, because a rough burr cuts thread on the line, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: a finish that tarnishes or rubs off after washing, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Button |
|---|---|
| Ligne | 28L / 18 mm |
| Attachment | shank back |
| Base material | ABS Plastic |
| Finish / process | Ultrasonic Welding |
| Colour options | 16 Pantone-matched shades |
| Packing | reel packed |
| MOQ | 1000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 15-50 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; colour fastness to washing, rubbing and light |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Embossing — available on ABS Plastic, quoted per position and per colour.
- Stamping — available on ABS Plastic, quoted per position and per colour.
- Antique Brass Plating — available on ABS Plastic, quoted per position and per colour.
- Die-Casting — available on ABS Plastic, quoted per position and per colour.
- Rubber Coating — available on ABS Plastic, quoted per position and per colour.
- Epoxy Dome — available on ABS Plastic, quoted per position and per colour.
- Soft Enamel Fill — available on ABS Plastic, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed ligne
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with ultrasonic welding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole burr.
FAQ
Which compliance documents do you provide?
We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
Start your button programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
