Custom Button — Polyethylene (PE) with Debossing
We supply button to garment factories and brands, built in Polyethylene (PE) with debossing for denim and workwear programmes. On a trim like this the specification that decides the outcome is wash and dry-clean stability of the finish, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Button |
|---|---|
| Ligne | 20L / 12.5 mm |
| Attachment | covered fabric |
| Base material | Polyethylene (PE) |
| Finish / process | Debossing |
| Colour options | 24 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 1000 pieces per style per finish |
| Sampling | 10 working days, 5 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | REACH and GPSR documentation; CPSIA lead and phthalate testing |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Rhinestone Setting — available on Polyethylene (PE), quoted per position and per colour.
- Ultrasonic Welding — available on Polyethylene (PE), quoted per position and per colour.
- Epoxy Dome — available on Polyethylene (PE), quoted per position and per colour.
- Chrome Plating — available on Polyethylene (PE), quoted per position and per colour.
- Sewn Edge — available on Polyethylene (PE), quoted per position and per colour.
- Gunmetal Plating — available on Polyethylene (PE), quoted per position and per colour.
- Paint Spray — available on Polyethylene (PE), quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed ligne
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with debossing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same wash and dry-clean stability of the finish.
FAQ
How long does sampling take?
A first sample takes 10 working days, and each revision about 5 days.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
Start your button programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
