Custom Button — Wool Felt with Overlocked Edge
We supply button to garment factories and brands, built in Wool Felt with overlocked edge for denim and workwear programmes. On a trim like this the specification that decides the outcome is hole burr, because a rough burr cuts thread on the line, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Button |
|---|---|
| Ligne | 16L / 10 mm |
| Attachment | covered fabric |
| Base material | Wool Felt |
| Finish / process | Overlocked Edge |
| Colour options | 6 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 3000 pieces per style per finish |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 15-50 days after approval |
| Compliance | GB 18401 safety classification with GB/T 29862 fibre labelling; salt spray test for metal finishes |
| Ship to | Shanghai or Shenzhen (Mainland China) |
What buyers can customise
- Gunmetal Plating — available on Wool Felt, quoted per position and per colour.
- UV Printing — available on Wool Felt, quoted per position and per colour.
- Pantone Colour Matching — available on Wool Felt, quoted per position and per colour.
- Laser Engraving — available on Wool Felt, quoted per position and per colour.
- Injection Moulding — available on Wool Felt, quoted per position and per colour.
- Stamping — available on Wool Felt, quoted per position and per colour.
- Rubber Coating — available on Wool Felt, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed ligne
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with overlocked edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole burr.
FAQ
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
How long does sampling take?
A first sample takes 14 working days, and each revision about 3 days.
Start your button programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
