Custom Button in Stainless Steel with Epoxy Dome for Outerwear and Jacket Programmes

Custom Button — Stainless Steel with Epoxy Dome

We supply button to garment factories and brands, built in Stainless Steel with epoxy dome for uniform and corporate programmes. On a trim like this the specification that decides the outcome is shade match across a full box, since buttons are bought by the gross, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Ultrasonic Welding — available on Stainless Steel, quoted per position and per colour.
• Rhinestone Setting — available on Stainless Steel, quoted per position and per colour.
• Rose Gold Plating — available on Stainless Steel, quoted per position and per colour.
• Sequin Stitching — available on Stainless Steel, quoted per position and per colour.
• Hot Foil Stamping — available on Stainless Steel, quoted per position and per colour.
• Tassel Finish — available on Stainless Steel, quoted per position and per colour.
• Overlocked Edge — available on Stainless Steel, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed ligne
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with epoxy dome applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same shade match across a full box.

FAQ

Which compliance documents do you provide?

We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.

What is the minimum order?

Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Start your button programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.