Custom Button in Resin with Injection Moulding for Denim and Workwear Programmes

Custom Button — Resin with Injection Moulding

We supply button to garment factories and brands, built in Resin with injection moulding for uniform and corporate programmes. On a trim like this the specification that decides the outcome is wash and dry-clean stability of the finish, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: colour drift between the approved sample and the bulk trim, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Screen Printing — available on Resin, quoted per position and per colour.
• Gold Plating — available on Resin, quoted per position and per colour.
• UV Printing — available on Resin, quoted per position and per colour.
• Chrome Plating — available on Resin, quoted per position and per colour.
• Digital Printing — available on Resin, quoted per position and per colour.
• Dye-Sublimation Printing — available on Resin, quoted per position and per colour.
• Gunmetal Plating — available on Resin, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed ligne
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with injection moulding applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same wash and dry-clean stability of the finish.

FAQ

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Which compliance documents do you provide?

We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.

Start your button programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.