Custom Interlining — Cotton with Epoxy Dome
We supply interlining to garment factories and brands, built in Cotton with epoxy dome for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is shrinkage match to the shell fabric, or the panel bubbles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Interlining |
|---|---|
| Weight | 120 gsm |
| Type | non-woven interlining |
| Base material | Cotton |
| Finish / process | Epoxy Dome |
| Colour options | 8 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 500 pieces per style per finish |
| Sampling | 7 working days, 5 days per revision |
| Bulk lead time | 15-50 days after approval |
| Compliance | GSO conformity with Arabic labelling; EN 71 part 3 for decorative components |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Piece Dyeing — available on Cotton, quoted per position and per colour.
- Mercerised Finish — available on Cotton, quoted per position and per colour.
- Braided Weave — available on Cotton, quoted per position and per colour.
- Paint Spray — available on Cotton, quoted per position and per colour.
- Overlocked Edge — available on Cotton, quoted per position and per colour.
- Rubber Coating — available on Cotton, quoted per position and per colour.
- Stamping — available on Cotton, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed weight
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with epoxy dome applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same shrinkage match to the shell fabric.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 7 working days, and each revision about 5 days.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
Start your interlining programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
