Custom Shoulder Pad — Spandex Core with UV Printing
We supply shoulder pad to garment factories and brands, built in Spandex Core with uv printing for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is recovery after compression, because a pad that flattens is visible, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: a finish that tarnishes or rubs off after washing, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Shoulder Pad |
|---|---|
| Thickness | 6 mm |
| Type | sleeve head pad |
| Base material | Spandex Core |
| Finish / process | UV Printing |
| Colour options | 24 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 2000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | REACH and GPSR documentation; EN 71 part 3 for decorative components |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Rubber Coating — available on Spandex Core, quoted per position and per colour.
- Hard Enamel Fill — available on Spandex Core, quoted per position and per colour.
- Mercerised Finish — available on Spandex Core, quoted per position and per colour.
- Epoxy Dome — available on Spandex Core, quoted per position and per colour.
- Knitted Structure — available on Spandex Core, quoted per position and per colour.
- Stamping — available on Spandex Core, quoted per position and per colour.
- Heat-Cut Edge — available on Spandex Core, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed thickness
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with uv printing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same recovery after compression.
FAQ
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Start your shoulder pad programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
