Custom Shoulder Pad — Nylon (PA) with Paint Spray
We supply shoulder pad to garment factories and brands, built in Nylon (PA) with paint spray for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is recovery after compression, because a pad that flattens is visible, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: a supplier who disappears once the deposit is paid, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Shoulder Pad |
|---|---|
| Thickness | 25 mm |
| Type | moulded shoulder pad |
| Base material | Nylon (PA) |
| Finish / process | Paint Spray |
| Colour options | 6 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 5000 pieces per style per finish |
| Sampling | 7 working days, 5 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | GSO conformity with Arabic labelling; EN 71 part 3 for decorative components |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Pleating — available on Nylon (PA), quoted per position and per colour.
- Embroidery — available on Nylon (PA), quoted per position and per colour.
- Sewn Edge — available on Nylon (PA), quoted per position and per colour.
- UV Printing — available on Nylon (PA), quoted per position and per colour.
- Paint Spray — available on Nylon (PA), quoted per position and per colour.
- Piece Dyeing — available on Nylon (PA), quoted per position and per colour.
- Heat-Cut Edge — available on Nylon (PA), quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed thickness
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with paint spray applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same recovery after compression.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
Start your shoulder pad programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
