Custom Button — Neoprene with Epoxy Dome
We supply button to garment factories and brands, built in Neoprene with epoxy dome for denim and workwear programmes. On a trim like this the specification that decides the outcome is hole burr, because a rough burr cuts thread on the line, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Button |
|---|---|
| Ligne | 40L / 25 mm |
| Attachment | 2-hole sew-through |
| Base material | Neoprene |
| Finish / process | Epoxy Dome |
| Colour options | 24 Pantone-matched shades |
| Packing | reel packed |
| MOQ | 3000 pieces per style per finish |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | REACH and GPSR documentation; salt spray test for metal finishes |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Die-Casting — available on Neoprene, quoted per position and per colour.
- Chrome Plating — available on Neoprene, quoted per position and per colour.
- Overlocked Edge — available on Neoprene, quoted per position and per colour.
- Antique Silver — available on Neoprene, quoted per position and per colour.
- Heat Transfer Printing — available on Neoprene, quoted per position and per colour.
- Epoxy Dome — available on Neoprene, quoted per position and per colour.
- Brushed Finish — available on Neoprene, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed ligne
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with epoxy dome applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole burr.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 14 working days, and each revision about 5 days.
Start your button programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
