Custom Cord Stopper — Aluminium with Injection Moulding
We supply cord stopper to garment factories and brands, built in Aluminium with injection moulding for uniform and corporate programmes. On a trim like this the specification that decides the outcome is spring life across repeated release cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare UKCA and REACH documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Cord Stopper |
|---|---|
| Bore | 8 mm |
| Type | single-hole toggle |
| Base material | Aluminium |
| Finish / process | Injection Moulding |
| Colour options | 6 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 3000 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | UKCA and REACH documentation; EN 71 part 3 for decorative components |
| Ship to | Felixstowe (the United Kingdom) |
What buyers can customise
- Brushed Finish — available on Aluminium, quoted per position and per colour.
- Dye-Sublimation Printing — available on Aluminium, quoted per position and per colour.
- Sewn Edge — available on Aluminium, quoted per position and per colour.
- Paint Spray — available on Aluminium, quoted per position and per colour.
- Anti-Rust Treatment — available on Aluminium, quoted per position and per colour.
- Heat Transfer Printing — available on Aluminium, quoted per position and per colour.
- Hot Foil Stamping — available on Aluminium, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed bore
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring life across repeated release cycles.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What is the minimum order?
Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your cord stopper programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
