Custom Cord Stopper in ABS Plastic with Heat Transfer Printing for Outerwear and Jacket Programmes

Custom Cord Stopper — ABS Plastic with Heat Transfer Printing

We supply cord stopper to garment factories and brands, built in ABS Plastic with heat transfer printing for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is hole tolerance, so the cord threads without forcing, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Overlocked Edge — available on ABS Plastic, quoted per position and per colour.
• Nickel Plating — available on ABS Plastic, quoted per position and per colour.
• Hard Enamel Fill — available on ABS Plastic, quoted per position and per colour.
• Gold Plating — available on ABS Plastic, quoted per position and per colour.
• Soft Enamel Fill — available on ABS Plastic, quoted per position and per colour.
• Ultrasonic Welding — available on ABS Plastic, quoted per position and per colour.
• Mirror Polish — available on ABS Plastic, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed bore
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with heat transfer printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole tolerance.

FAQ

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

What is the minimum order?

Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.

How long does sampling take?

A first sample takes 10 working days, and each revision about 4 days.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Start your cord stopper programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.