Custom Cord Stopper — Aluminium with Epoxy Dome
We supply cord stopper to garment factories and brands, built in Aluminium with epoxy dome for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is spring life across repeated release cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Cord Stopper |
|---|---|
| Bore | 5 mm |
| Type | cord end |
| Base material | Aluminium |
| Finish / process | Epoxy Dome |
| Colour options | 6 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 500 pieces per style per finish |
| Sampling | 7 working days, 4 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; EN 71 part 3 for decorative components |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Embossing — available on Aluminium, quoted per position and per colour.
- Debossing — available on Aluminium, quoted per position and per colour.
- Antique Brass Plating — available on Aluminium, quoted per position and per colour.
- Chrome Plating — available on Aluminium, quoted per position and per colour.
- Digital Printing — available on Aluminium, quoted per position and per colour.
- Black Oxide — available on Aluminium, quoted per position and per colour.
- Heat Transfer Printing — available on Aluminium, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed bore
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with epoxy dome applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring life across repeated release cycles.
FAQ
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your cord stopper programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
