Custom Cord Stopper in Spandex Core with Hard Enamel Fill for Uniform and Corporate Programmes

Custom Cord Stopper — Spandex Core with Hard Enamel Fill

We supply cord stopper to garment factories and brands, built in Spandex Core with hard enamel fill for denim and workwear programmes. On a trim like this the specification that decides the outcome is hole tolerance, so the cord threads without forcing, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Gunmetal Plating — available on Spandex Core, quoted per position and per colour.
• Sewn Edge — available on Spandex Core, quoted per position and per colour.
• Powder Coating — available on Spandex Core, quoted per position and per colour.
• Hard Enamel Fill — available on Spandex Core, quoted per position and per colour.
• Embossing — available on Spandex Core, quoted per position and per colour.
• Mirror Polish — available on Spandex Core, quoted per position and per colour.
• Hot Foil Stamping — available on Spandex Core, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed bore
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with hard enamel fill applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole tolerance.

FAQ

How long does sampling take?

A first sample takes 10 working days, and each revision about 3 days.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

Start your cord stopper programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.