Custom Cord Stopper — Aluminium with Overlocked Edge
We supply cord stopper to garment factories and brands, built in Aluminium with overlocked edge for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is spring life across repeated release cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: packing that arrives mixed and unusable on the line, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Cord Stopper |
|---|---|
| Bore | 3 mm |
| Type | barrel stopper |
| Base material | Aluminium |
| Finish / process | Overlocked Edge |
| Colour options | 8 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 500 pieces per style per finish |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | GB 18401 safety classification with GB/T 29862 fibre labelling; EN 71 part 3 for decorative components |
| Ship to | Shanghai or Shenzhen (Mainland China) |
What buyers can customise
- Die-Casting — available on Aluminium, quoted per position and per colour.
- Dye-Sublimation Printing — available on Aluminium, quoted per position and per colour.
- Soft Enamel Fill — available on Aluminium, quoted per position and per colour.
- Heat Transfer Printing — available on Aluminium, quoted per position and per colour.
- Offset Printing — available on Aluminium, quoted per position and per colour.
- Powder Coating — available on Aluminium, quoted per position and per colour.
- Overlocked Edge — available on Aluminium, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed bore
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with overlocked edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring life across repeated release cycles.
FAQ
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How long does sampling take?
A first sample takes 7 working days, and each revision about 3 days.
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
Start your cord stopper programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
