Custom Button in Polypropylene (PP) with Die-Casting for Denim and Workwear Programmes

Custom Button — Polypropylene (PP) with Die-Casting

We supply button to garment factories and brands, built in Polypropylene (PP) with die-casting for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is hole burr, because a rough burr cuts thread on the line, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.

The failures here are predictable: inconsistent sizing between production runs, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Brushed Finish — available on Polypropylene (PP), quoted per position and per colour.
• Injection Moulding — available on Polypropylene (PP), quoted per position and per colour.
• Pantone Colour Matching — available on Polypropylene (PP), quoted per position and per colour.
• Soft Enamel Fill — available on Polypropylene (PP), quoted per position and per colour.
• Black Oxide — available on Polypropylene (PP), quoted per position and per colour.
• Offset Printing — available on Polypropylene (PP), quoted per position and per colour.
• Antique Brass Plating — available on Polypropylene (PP), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed ligne
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with die-casting applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole burr.

FAQ

Which compliance documents do you provide?

We prepare GRS recycled content claim and the supporting test reports for the destination market.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How long does sampling take?

A first sample takes 14 working days, and each revision about 5 days.

Start your button programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.