Custom Cord Stopper — Natural Rubber with Injection Moulding
We supply cord stopper to garment factories and brands, built in Natural Rubber with injection moulding for denim and workwear programmes. On a trim like this the specification that decides the outcome is grip force on the actual cord, tested both dry and wet, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: a finish that tarnishes or rubs off after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Cord Stopper |
|---|---|
| Bore | 5 mm |
| Type | single-hole toggle |
| Base material | Natural Rubber |
| Finish / process | Injection Moulding |
| Colour options | 8 Pantone-matched shades |
| Packing | carded |
| MOQ | 2000 pieces per style per finish |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 25-50 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; colour fastness to washing, rubbing and light |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Offset Printing — available on Natural Rubber, quoted per position and per colour.
- Antique Silver — available on Natural Rubber, quoted per position and per colour.
- Antique Brass Plating — available on Natural Rubber, quoted per position and per colour.
- Hot Foil Stamping — available on Natural Rubber, quoted per position and per colour.
- UV Printing — available on Natural Rubber, quoted per position and per colour.
- Embossing — available on Natural Rubber, quoted per position and per colour.
- Gunmetal Plating — available on Natural Rubber, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed bore
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same grip force on the actual cord.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
How long does sampling take?
A first sample takes 14 working days, and each revision about 5 days.
Start your cord stopper programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
